Sampling Techniques for Hay Analysis - Agriculture and Industry

Issues of importance and related to the BC Horse Industry and Agriculture.

Disclaimer: The information and services listed in the HCBC forums are intended to facilitate accessibility to the professionals, products and services that play a part in the horse industry. HCBC does not assume responsibility for errors, omissions or subsequent changes in the information provided. While readers are encouraged to use the products and services of the merchants and users of this forum, Horse Council BC does not recommend, endorse, or guarantee the products and services of advertisers listed.

Back

Sampling Techniques for Hay Analysis

HCBC Staff
Created: December 10, 2014

Kentucky Equine Research posted a great article on how to get the best hay sample for an accurate analysis

Accurate hay analysis depends on sample quality. In short, laboratories cannot do a worthwhile job if they have only poor samples to analyze. Laboratory personnel tell stories of receiving a complete flake or slab of hay, a handful of hay pulled from a bale or grabbed from the hay feeder, or a small wad of hay cut up with scissors. These submissions are not quality samples and cannot be used by a laboratory.

Any sampling of dry forages that involves grabbing a handful of material usually results in a subsample that is poorer in quality than the actual nutrient content. This is particularly true with alfalfa (lucerne) hay because grab sampling typically results in mostly stems, with the finer and more fragile leaves shaking off. Leaves contain most of the nutrients, being higher in both protein and digestibility than the stems. Any procedure that results in leaf loss will have a negative impact on the analysis. The opposite also holds true. Sampling that results in concentrating the leaves will make the sample look better than the forage actually is.

The only way to obtain a proper hay sample is by using a bale probe or corer. This is typically a metal tube from 38 to 48 cm (15 to 18 in) long and sharpened at one end. Depending upon the type of probe, it is either hand-operated or may be coupled to an electric drill. Feed stores and agricultural extension offices may have corers that can be borrowed.
Bales should be probed in the center of the small, square end. The probe takes a representative cross section as it spins and cuts its way through the bale. The resulting core sample will proportionately reflect the leaf and stem material in the bale. Typically, obtaining and combining core samples from 10 to 20 bales will form a worthy composite sample.

Add your Reply

Reply